Classicnewcar.us


CDNN SPORTS - BERETTA 92 96 M9 FACTORY PARTS KIT 20 PIECE

CDNN SPORTS - BERETTA 92 96 M9 FACTORY PARTS KIT 20 PIECE

To prevent loss of disassembly button and spring, be sure to release button pressure slowly after the removal of the disassembly latch lever.1. Push in on the disassembly latch button (1) and rotate the disassembly latch lever (2) upward until contacting the slide rail. While maintaining firm pressure on the disassembly latch button (1|, pull out, and rotate upward to remove the disassembly latch lever (2).2. Remove the disassembly latch button (1) and spring (2).NOTEWhen removing each pistol grip, the lockwashers may remain seated or come loose. Be careful not to lose them.3. Remove the grip screws (1). Using the forefinger, insert the finger into the magazine well and gently lift up on the pistol grip (2). Repeat the procedure to remove the other grip.4. Place the receiver on the left side. Locate the trigger bar spring (1) just below the trigger bar (2). With the tip of fingernail or screwdriver, or the use of needle-nose pliers, carefully unseat the upper portion of the trigger bar spring Ul from the trigger bar (2). Gently lift up and remove the trigger bar spring (1) from the hole in the receiver.5. To remove the trigger bar (2), unseat the trigger bar by inserting the forefinger into the receiver and pushing outward on the trigger bar. Pull the trigger bar out from the right side of the receiver (3).6. Rotate the slide stop (1} slightly upward and pull out until the slide stop |1| can rotate freely downward Remove the slide stop 111 and slide stop spring {2). DISASSEMBLY (cont) +1 0 Where The Extractor Hook Pistol About | Contact | Privacy Policy | Resources



Report illegal firearms activity to 1-800-ATF-GUNS or your local police department. New unfired Beretta 92FS Inox 9mm.Comes with everything from the factory,2 15 round magazines, lock,manual,bore brush,plastic case, extra grips,snap caps and 100 rounds of ammo. Originally had black controls but replaced with stainless ones.Replaced trigger, trigger pin,guide rod,slide release/lock,extractor,grip screws,trigger bar,disassembly latch and button,hammer spring cap and magazine release.l also installed skeletonized hammer, Wilson Combat trigger return spring and Wilson Combat 16 pound hammer spring. Will come with all original parts.Purchased in February of this year.Have paperwork and receipt.Email or text or call 9207131762.Still available if ad posted.$800.00 Always comply with local, state, federal, and international law. ARMSLIST does not become involved in transactions between parties. Review our privacy policy and terms of use for more information. Report Illegal Firearms Activity to 1-800-ATF-GUNS.





#Contact US #Terms of Use #Privacy Policy #Earnings Disclaimer